Pitchcar Giant Loop

for PitchCar (1995)

privatePublic + Follow

Inserts

Free

View Print on Thingiverse

Please support privatePublic by Liking/Boosting their Print on Thingiverse.

This is a giant loop for Pitchcar that has the same footprint as a left 90 then right 90. I split it into four pieces that fit on my Ender 3, just print then glue it together.

UPDATE 3/5/2019: I finally got the whole thing printed and it came out great. I ended up gluing together the track connectors to their respective loops, but not the loop halves together. This is to make it easier to store as well as to make it easier to fit into track layouts. I've included a picture of my finished loop in the thumbnails.

From BoardGameGeek

- another short straight looping section, this is much taller and it has rails that will guide the disc so it mainly just requires a power shot to make it up and around. It is also notable because it was designed in two sections that can both be printed without supports when properly oriented (well, I used supports for the grooves). This allows for much easier printing as well as storage. It has grooves in the top and bottom that allow a large rubber band to hold it together during play and some teeth that ensure alignment of the sections. PitchCar Giant Loop