Log in to join the conversation.
Wind-Proof Playing Card Holder for Coyote
Please support Red Cocoon by Liking/Boosting their Print on Printables.
Printed at 0.3 mm layer height but you may use a smaller number if you want more clarity at the top where it is very slightly curved.
Infill that I used is 10% Gyroid but I think even 5% should works fine.
This model is designed to be wind-proof in one-direction only but it will still catches the card on the other direction so that it is unlikely to fall out.
Additional hardware (Optional):
1) 2x M5 16mm screws and nuts
2) Washers (and super glue)
If you want to make the base heavier, you may add 2 M5 screws and nuts to the side by pressing them into the hole on the side. If you need it to be heavier, you may glue on washers to the bottom.
