Star Wars AT-AT Wind-Up card Kit & Non-Wind-Up

Boost Me Do you like this model? If so, please give it a boost — it really means a lot to me!

Hello!

For this model, a layer height of 0.12 mm is recommended, but 0.08 mm is also possible.

Additionally, you can choose to assemble it either as a wind-up (spring-powered) version or a non-wind-up version, so please keep that in mind!

*Some users told us that certain parts had a higher chance of print failure.
So I put those tricky parts together into a new F3Runner, and also added brims to the existing parts to make printing easier.

I’ve also updated the assembly guide accordingly, so please check it out when putting the parts together!

(Check the type of wind-up spring used )

https://a.aliexpress.com/_om0TyX5

https://link.coupang.com/a/cJz4Qp

For assembly, please refer to the included instructions or the video.