Log in to join the conversation.
Board Game Insert: Valley of the Kings / Ve stínu pyramid
Please support Stínovlas by Liking/Boosting their Print on Printables.
This is just a card box filling the interior of the game box. The original paper divider was too low and cards were getting mixed during transportation.
• Inner box dimensions: [93mm, 133mm, 33mm] Check this if you own different version than Czech ("Ve stínu pyramid").
• Lid lift: None.
• Sleeves: Probably not. I didn't test it, but the fit is pretty tight even with unsleeved cards.
##
I recommend to put the rulebook below the cardbox (but you can put it on top as well). I store starting decks in one compartment, separated by tomb and help cards. The second and third era cards go to the second compartment. This allows for a quick game setup.
• print card-box.stl once
I printed from PLA. It's possible to print without any top and bottom layers. I prefer Honeycomb, but other infills such as Grid should work as well. This saves both time and the amount of filament used. If you do this, consider increasing infill extrusion width and infill percentage, to create stronger bottom.
##
Full OpenSCAD source code is available on https://github.com/stinovlas/boardgame-inserts .
