Heat Deluxe insert +3 exp +sleeve +side +low PLA

This is my deluxe all-in HEAT insert (all 3 expansions). It brings order to chaos. I have no promos but I am sure they will fit somewhere…..there is a lot of open space that can be utilized. I find that I rarely play anything other than the base game with upgrades and it is so much fun!

ALL STLs are loaded. On the plate, I included a white player box, and one lid of each color. If you print in one color, you will need a total of 9 player trays, 1 all cardboard tray, and 10 lids…..I simplifed the design to the point that there are few trays that are different (player trays, and sponsor trays are the same). The cardboard tray has no hole in the bottom but otherwise is the same. All of player, cardboard and sponsor trays use the same lid.

If you have questions, reach out and I will try to provide support.

Features:

• REDUCED PLA.

• Supports base game, heavy rain expanansion, rocky roads expansion and Tunnel vision expansion.

• Side storage.

• No lid lift.

• designed for sleeve kings (will work with thin or no sleeves as well)

• All boards on the bottom.

• Hole in the bottom to make card removal easy (the only way with the gear and car in the player box on top.

• Each player box is basically the same. You can print in one color (I printed the lids in player color meaning no AMS is required for them). There are 10 boxes (9 players and one for the sponsors).

• I added an 11th box with the hole on the bottom removed for all cardboard tiles. Just lay them in the box. I printed it in a different color (copper) but it can be the same color of course.

• The side card trays and lids are all the same. Just print 6 trays and 6 lids. The openings on the sides make it easy to identify what cards are in each tray. You have Heat, stress, 3 boxes of upgrades (2 of which are the one cog, and 1 is 2 cog and the rest). Just split the other cards up as you like. For card side trays that have 2 types of cards, just flip so you can see them in the card tray opening…. it makes them easy to identify.

• I have 4 scorepads (some have been used of course), and they fit nicely in a corner without any printed component and do not lift the lid…..I like it.

The moniker is in the 3mf with an AMS paint job on top, or single color (10% infill for both). I (as always) leave a little room in the box to grab boxes, but this moniker also acts as a plug, so it opens up space to remove card side trays more easily.

If you like this insert, then please consider following me!