V2! Miniatures Paint Brush Cleaning Pot

Water leak issues and how to avoid these:

If printing PLA the cup should be fine for a session then it needs emptying, don't leave water in it. I've been fine up to 4 hours

Printing with wet PLA can increase the issue due to layer adhesion

Printing with higher temperature has shown to help

Printing solid can help but is a lot of filament

PETG is the better filament to print with if you have it

Thank you to everyone for all of the feedback I have received, I've made some of the suggested improvements.

Here is an update to my paint brush cleaning pot for painting miniatures

Features/improvements

Rest over top for current brush

11 brush holder at the rear instead of previous 3

Grooves on the bottom and sides for cleaning brushes

Deeper grooves towards top for getting a tip on even the thicker brushes

Boost Me All of my models are free to be used commercially so why not boost me to show support?