Log in to join the conversation.
Flick 'em Up! Component Holder (KS Edition)
Please support That Lucas by Liking/Boosting their Print on Printables.
This is a component holder for all the cardboard token pieces for Flick 'em Up!
I printed the component holder at 5% infill. It fit's the Kickstarter Edition box. It's small enough, it could be used for the retail edition (not tested, don't own it), you may need to modify your retail insert.
Though the lid is snug enough to hold on it's own. I recommend printing the lid at 9% honeycomb insert, no top nor bottom layers.
Optionally, you can print the height spacer. It was created just to hoist up the holder so it's flush with the instructions, which then makes it flush with the lid. Not needed, but I like my stuff to fill the box in case the lid feels like jostling open. I recommend printing it at 3% and vertically. I print it vertically so the walls make a "top" and "bottom" as I don't print it with bottom or top layers as well.
Category: 3D Printing
Small component box with lid. Sized for the KS box. Not tested for retail box, it will fit, may need to mode retail insert. Feel free to remix it, but it should woul
/pic3032595.png)
/pic2645166.png)
