King of Tokyo: Even More Wicked board organizer

This is two clips for King of Tokyo: Even More Wicked micro expansion. It's a super sweet expansion to use with Power Up to unlock even more combos; so it gets used everyone we play! And when I play, it's usually with my kids, who are prone to bumping the table or board(s). So this is my solution to keep everything in place!

There are two versions, one is longer and can be put into a Monster Box, the other versions are shorter (print 2-3 combiner clips and one of each of the Wickedness powers). Also, not the combiner clip has a notch in it. The notch goes to the KoT board as it's slightly thinner than the Wickedness Board so has better fit.

Both, the combiner and wickedness board clips fit in my Monster Box Organizer that I designed https://www.thingiverse.com/thing:6896917 . Though the Wickedness board clips, sets on top of the characters, so it fits perfectly. Again, made shorter versions for the standard game box.

I used 20% infill and used supports. The supports were to make sure they were uniform and even and yes, I got in there and scrapped some of the support material off, just to make sure they were smooth. All in all, I noticed printing the combiner on it's side, the support plate would slightly warp and the measurements would be a little tighter and not fit.

I also paused at layer 5 to do two colors, (I printed with the combiner too, so it's both green and black, whichever side you prefer.

Category: 3D Printing