Deception Replacement Box and Insert

1-29-25 Edit: One person reported their bullets were too tight, increased size of holes to 13mm.

I bought a secondhand copy of Deception and the box was trashed and dirty, so I bought the expansion hoping it could fit. I actually did make it fit in the expansion box with a ton of lid lift, but have been planning a full 3D printed box for a while.

Sleeved role cards, unsleeved Means/Clues. You might be able to fit sleeved base game cards, but I haven't tried it. Box is roughly 7" square, 175mm.

Multicolor and single color versions available. Needs 4 x (8x3mm) magnets.

Print one top and one bottom as oriented, flat sides down. Align the hinge and put a scrap piece of filament through the hole. Leave 1-2mm on each side and use a heat source to melt the ends and press flat against a hard surface.

Carefully insert the magnets in the right orientation. Print my Magic Magnet Tool first so you don't mess up the polarity.

Happy Gaming!

---------------

If you love board games check out my 100+ free designs here on Printables! Or inserts available for purchase on Printables . And check out all the designs for sale at my Etsy shop Taylor Jane Design Co.