Marvel United - Card Board Location Storage

Marvel United - Card Board Location Storage

Notes:

• No Supports Needed.

• These are not Print in Place Hinges. Use a short piece of filament as the hinge pin. I used a lighter to melt/mash the end of the filament to keep it in place Everything was Printed at .2 Layer Height. I used a brim on most of my prints.

There are 4 Boxes in Total. Seasons 1&2 were designed together while Season 3 Came Later.

If you have any questions please do not hesitate to ask. I am always happy to help.

Marvel united Seasons 1 &2 Locations:

1x MU_S1andS2_Locations_Top_v0

1x MU_S1and2_Locations_Bottom_v1

Marvel United Seasons 1 & 2 Villains Dashboards:

1x MU_Villains_Dashboards_Top_v1

1x MU_Villains_Dashboards_Bottom_v1

Marvel United Season 3 (Multiverse) Locations:

1x MU_Multiverse_Locations_Top_v0

1x MU_Multiverse_Locations_Bottom_v0

Marvel United Season 3 (Multiverse) Villains Dashboards:

1x MU_Multiverse_Villains_Top_v0

1x MU_Multiverse_Villains_Bottom_v0

I designed this to be storable both flat on the bottom and sideways in a Kallax.

Noted Instructions:

All were Printed at .2mm Layer Height. 15% Cubic Infill 5 Top and 3 Bottom Layers