King of Tokyo Figures Rugged Magnetic Storage Box

There are some great models created by @VirtuallyJason for King Of Tokyo models that I'll link below. I was keeping these in a cardboard box which sucked so I decided I wanted something nicer to keep them in. In order to keep them from sliding around I also made an magnetic base you can add to the models and then there are places where you can put 6x2mm round magnets in the box during the print to hold everything in place.

Printing Suggestions:

• .2 Layer height

• 15% infill

• Set a pause near the start so that you can place the magnets in midprint, I suggest using a drop of super glue to hold them in place so they dont pop out while printing.

King of Tokyo Figures by @VirtuallyJason

• https://www.printables.com/model/165145-king-of-tokyo-gigazaur-proxy

• https://www.printables.com/model/165138-king-of-tokyo-alienoid-proxy

• https://www.printables.com/model/165133-king-of-tokyo-cyberkitty-proxy

• https://www.printables.com/model/165144-king-of-tokyo-the-king-proxy

• https://www.printables.com/model/165142-king-of-tokyo-space-penguin-proxy

• https://www.printables.com/model/402384-king-of-tokyo-meka-dragon-proxy