UFS-118 Polygon Fox Dice Tower

So this remix on Thingiverse is actually from a design on Myminifactory.

https://www.myminifactory.com/object/3d-print-blink-fox-dice-tower-108734

The design on Myminifactory credits Jukka Seppänen's Blink Fox. But I don't care about that, because I used a different fox.

I just liked the idea of a Fox dice tower, but I wanted a different fox. So I used this low poly fox, https://www.thingiverse.com/thing:937740 .

I first tried just the fox alone, but the dice rolled too far. I then added a small tray to catch the dice.

At 100% scale, at least a 15mm dice will fit.

You may want to use supports but keep it to a minimum. I found them hard to remove.

Use low infill around 15%. Use coarse resolution to speed up print time. It is a poly fox after all.

Printer Brand:

Prusa

Printer:

I3 MK3S

Rafts:

No

Supports:

Yes

Resolution:

0.24

Infill:

15%

Filament:

any pla red

Category: Hobby