Twilight Imperium 4th Edition Player Dashboard

Boost Me I want to make more crazy models like this one and share them for free! Your boost helps me keep going!

You know, I know: Twilight Imperium is a massive table hog. I play Twilight Imperium on a ~ 90cm x 220 cm (~6-7ft table) and always struggled find solutions to organize players components. Now that I have a 3D printer I figured it was time to try something a bit over the top that could be both functional and offer a great table presence to enhance the gameplay experience. I have seen people creating custom tables dedicated to Twilight Imperium, but I didn't want to go that far. So my middle ground is this player dashboard.

Check out my other Twilight Imperium models!

• 3 card holder slots along the long side of the main player mat, plus additional card holders distributed across the dashboard for extra card storage

• Frames keep the faction mat, the leader mat and the command board mat in place and offer additional card storage if needed

• Compatible with my Strategy Card holders: you can attach a strategy card using that holder on either side of the dashboard (making it also compatible with 4-player games)

• The speaker token can be attached at the front or at one of the sides instead of a strategy card (compatible with my Speaker Token holder or custom made metal speaker token holder, etc.)

• The underside has space to hold my Player Units tray , my Faction Box , the player's hand and there's space even for their mobile phone!

• The front can be used to place upright the player's scored objectives, and face-up promissory notes, such as "Support for the throne" or “Alliance” with the ability to put a control token in place just above each card.

• The front has additional upright card storage if needed

• Many decorative elements to make the dashboard not just functional but also look very cool!

This is a large model and each dashboard will consume about 750g of filament and take several hours to print, so before you commit I highly recommend you examine the model, perhaps even reach out to me if you have questions, and print a test (or parts of it) to give you an idea if it's the right fit for you.

No supports required! No glue required!

You need to print at least 6 of the 4 plates included in the main profile, or 8 to support 8 players.

The dashboards can be disassembled for storage and reassembled quickly with simple connectors. To assemble:

• Connect the two front pieces by sliding the sides together

• Slide the two big halves into the front pieces using the dovetail rails

• Insert first the leader board and then the command board along the guides, making sure they're snugly fit all the way down and flat

• Repeat with the faction board

To disassemble: remove first the smaller boards, then the faction board, and slide out the big pieces.

This model is an exclusive model and it's not meant for printing for commercial purposes. If you intend to sell prints from this design, please contact me, I'll be happy to discuss simple terms to make both us happy!

If you are considering to offer this model as a print for sale in your Etsy store or similar without my permission, please refrain to do so. Read above: there's an opportunity to do it legally with a simple message.