Log in to join the conversation.
Polyhedral Dice Box with Individual Dice Cells
Please support Vicpylon by Liking/Boosting their Print on MakerWorld.
This is a remix of the Stormlight Polyhedral Dice Box with some improvements.
There is enough room for three complete sets of RPG polyhedrals (D4,D6,D8,D10 x 2,D12, D20). Each die has a separate cell to prevent dice from damaging their anodized coating by banging into each other during transport.
Each cell has two cut-outs to make it easier to grab the dice while still preventing them from coming out, even if the box is turned upside down or shaken.
Take note of the D4 storage cell. It had to be modified so that the dice are stored upside down. This, combined with the slots in the cell allow the dice to be picked up more easily. Grabbing a D4 by the point is quite annoying, so the easiest solution was to store them upside down.
The only items not pictured are four magnets (D6x2mm, listed in the BOM below from Bambu) and some felt, leather or other material to line the top rolling surface for a softer roll.
I also have a template to cut the fabric/leather/felt for the lid if so desired. It is an optional print but makes lining the lid easier.
