Marvel United/DC United Insert for Painted Minis

All of the other inserts that I've seen have the minis loosely tossed in a bin. I wanted to design something that would give, at least, some protection to my painted minis. With this insert, the minis are held in place by pushing them into 30mm holes in the bottom of the insert. Push them by pressing your finger against the mini's base and not by pushing it from the top (some the minis are quite flimsy/fragile and could break if pushed from their tops).

Insert can hold up to 36 miniatures and an (un-calculated) number location cards. Pictured, it is holding the minis and locations for 2 core boxes and 2 expansions. Most of my tokens are stored separately in a custom box (see my other acrylic tokens project here: https://makerworld.com/en/models/2353857-marvel-united-dc-united-tokens ). My cards and remaining tokens are stored using this insert: https://makerworld.com/en/models/443246-marvel-united-insert

DISCLAIMER: The miniatures are held loosely in place at best. Without gentle handling and keeping the box upright, they'll likely fall over, etc. That said, with that caveat, it's working well for me. Plate 4 contains a small test model that you can print and test the fit without having to waste much filament.