Zombicide: Undead or Alive - Hero Horse Mount

This is my attempt at creating a mountable horse for any hero (assuming to replace those flat horse cardboard tokens) within Zombicide: Undead or Alive.

I used a combination of some simple shapes + logo and the great low poly horse by chemlife:
https://www.thingiverse.com/thing:925638

<b>V3:</B>
I reduced the overall height and tested a few prints. 100% is easy with room for other models that might fall over the base shape.

<b>90% fit the base a little tighter and I liked this size of the horse printed overall.</b>

<b>V5:</b>
Skipped a few minor tweaks to the feet/base in V4. I reduced the overall higher of the horse and made the hero ring sit lower in the horse so they weren't standing necessarily on the horse.

You can print V5 at 100% size. I even did 100% fill as the amount of filament was still very small. Be careful removing the supports around the bases. A few samples lost some legs that had to later be super glued back on :)