Welcome to the Dungeon Sliding Box Insert

A multi layered box insert for Welcome to the Dungeon board game.

Note that you really should use a brim to avoid warping of the lid which would cause the slide connection to not fit well.

Also note that the fittings for the hero cards are not super spacious so if your printer's tolerances are not very good, try not pushing the cards too hard in, they should enter with little force.

I printed with 5% infill and 20% infill right beneath the layer where the cards are in the middle part to avoid imperfections that could scratch the cards.

The tolerance between the parts is 0.3mm which was ok for me but does not work well if your parts warp too much.

https://boardgamegeek.com/boardgame/150312/welcome-dungeon