Gloomhaven / Frosthaven Ability Card Holder sleeved cards REMIX

##### UPDATE 2023-04-25 #####

Added new versions per @KeddeH_62998 for the geminate class with holders on both sides.

Made the middle section 1mm wider on all v6 per @Farmor_607069 to fit the arcane tinmen sleeves.

Added a rear section to hold whatever else might come up like burned cards.

Print flat on backside to avoid needing supports except for the models with the rear card holder.

##########

I loved the original design but I am cheap and impatient so I turned mosjef's Porsche into a Yugo.

This thing helps reduce the table top footprint, reduce clutter, and minimize confusion in the heat of battle when metal and blood is flying all over.

• Shrank wall thickness

• Shrank overall width

• Got rid of the pretty words

• Cut out a large chunk of the middle

• Generally bastardized the original design

I like this better than a dashboard due to its modular nature. And I can reuse for frosthaven later. Remix was done in tinkercad.

Credits:
https://www.thingiverse.com/thing:4555403
Linked is the good design, use mine if you are cheap and impatient.

Print Settings

Printer brand:

Creality

Printer:

Ender 3 Pro

Rafts:

No

Supports:

No

Resolution:

0.56mm

Infill:

0

Filament brand:

GST 3D

Filament color:

Yellow

Filament material:

PLA+

Notes:

Nozzle size:
1MM (if using 0.4mm nozzle, use 3 walls with infill line multiplier of 2 with 5% infill)

Outer Wall Wipe Distance:
0.4

Print Speed:
25

Initial Layer Speed:
15

Build Plate Adhesion Type:
Brim