VTOL Warrior for Battletech

The VTOL Warrior is a very common unit to be fielded by virtually any of the great houses due to its widespread adoption.

As even the greenist of MechWarriors (should) know to aim at its rotors, it also has among the highest pilot mortality rates of any combat vehicle. it primarily serves as a recon unit, due to its higher mobility and fragility, compared to other vehicles even being faster than most BattleMechs.

Print Recommendations:

This model only has 4 parts. The main helicopter, the two rotors, a choice from one of the 3 poles, and a hex base.

PLEASE NOTE:

The hex base and 3 different poles are provided for customization. BE AWARE that the poles cannot be printed with the included preset and using the 0.2 mm nozzle without risking failure, unless they are laid on their side. I highly recommend printing the poles and hex base separate using the standard 0.4 mm nozzle, and print the main model using the included preset.

Also, be careful when taking support off of the rotors.

Assembly:

1: Glue the rotor with a hole on first, then stack and glue the second rotor ontop.

2: Glue the desired pole onto the hex base.

3: Glue the helicopter onto the pole in its desired position.