PERFECT Gloomhaven/Frosthaven Standee Set with MAGNETS

https://www.printables.com/model/421859-magnetic-frosthavengloomhaven-standees-second-edit

Second edition features HP counter from both sides and other improvements - see the link for more information.

The Frosthaven finally arrived, so I printed the PERFECT Gloomhaven standees with the upgrade from Baltojikale (see links to original models). But the 10hp plates did not fit properly for me. The other issue was that the monster cards were falling out of the holder (maybe the Frosthaven ones are a bit thinner than those in original Gloomhaven).

So I remixed the design to be used with magnets. I modified the upgraded bottom part and the 10hp plates. And I used the upgraded top part and made the holders narrower by 0.1mm for the monster card and by 0.05mm in the stats card sections (for easy swapping).

Material needed: magnets 5x1.6 mm - 1x for every standee + 2x for every 10hp plate

Printed with PLA, 15% honeycomb infill. The standees are printed with 0.1mm layer with a pause command before layer 24 (set in Prusaslicer). The 10hp plate is printed with 0.2mm layer and set to change colour on layer 12 and stop before layer 21.

You need to make sure the orientation of magnets is the same in every print! The hole diameter is 5.1 mm, so it is a nice tight fit.

Fits in gloomhaven standee container: https://www.printables.com/model/165240-gloomhaven-standee-container

It works really well and I am happy with the outcome.