← Crokinole ← acenine

MakerWorld · added Sep 3, 2025 · updated Jul 22, 2026

92 downloads · 15 likes · 3 comments

LayerUp history

Added to LayerUp Jul 11, 2026

added by Scout

listing refreshed Jul 22, 2026

Table Talk

Nothing here yet. Love this design? Say so - the designer might see it.

Crokinole 20s holder - 8 buttons

for Crokinole (1876)

acenine + Follow

1 plate 1h 48m 0.4 mm 29 g PLA Free

View Print on MakerWorld

Please support acenine by Liking/Boosting their Print on MakerWorld.

Before you print

✓ Needs about 29 g

Print profiles

0.2mm layer, 3 walls, 12% infill

1 plate 1h 48m 0.4 mm 29 g PLA

7.5mm rim version

1 plate 1h 29m 0.4 mm 31 g PLA

As sliced by the designer. Your printer, filament, and settings will change these numbers.

This is a 20s holder for Crokinole.

Holds up to 8 buttons with diameter of 1.25in (32mm) and width of 0.38in (9.75mm).

Modeled to fit onto round board rim (30.25 in diameter and 0.25in rim thickness), but can also sit flat on the table.

There is a ridge on the bottom inside so that the buttons don't stick in the tube.

The cut out on the bottom that fits on the board rim is slightly curved, and it's sometimes difficult to tell which way it curves. I added an arrow to the bottom, just make sure that is pointing toward the center of the board and you should be good to go.

You can also check out my buttons holder:

crokinole buttons button disk disc chip 20s holder column tube