Edge of Darkness monster card holder

Card holder for Edge of Darkness. Attaches to original monster tower. The slots in the bottom are ALMOST enough to hold this in place with no adhesive, but I made it with the intent of gluing it permanently to the tower.

The slots are wider to make slotting the card in easier, they are deeper to make the cards harder to knock out. You can still knock the cards out, but it takes a lot more effort now, the channels are about 7 mm deep. Deep enough to hold the cards but not cover up any but the tiniest bottom row text that you can't read from across the table anyway.

There is another scrabble style card holder that clips on out there for free, and it is really nice, but I just didn't want the hassle of putting it on and off all the time and it was larger and more noticeable than I wanted.

Meant to be printed ‘upside down’ with the card slot openings on the print surface.

I printed this in 0.3mm layer height in pla. Most modern slicers should allow you to cut it into smaller pieces right in the slicer if it does not fit on your bed plate. Fits nicely on a prusa mk3s+ plate without having to turn it diagonal.