Karak / Carcassonne 4x4 tiles grid / grid

With the original grid, the locks were too loose for my taste, so I adjusted the accuracy of the locks, the tightness of the tile boxes and slightly reduced the height of the separating crosses. Thank you very much for the original model, which I only slightly completed to my satisfaction.

There are two versions available - V1 is really very accurate in locks, V2 is a bit looser - try what suits you better.

Holder for up to 16 pcs of these grids here:
https://www.printables.com/model/1158507-drzak-mrizek-grid-holder-karak-carcassonne

I printed on MK3S+, 0.20 Quality, PLA silver.
____________________________________________________________________________________

Original tile grid have a locking bits with a little too much play on my MK3S+. I tried to modify the grid to have tighter locks and tighter tile arrays. There are two versions available – precise V1 and slightly looser V2.

Holder for up to 16 of these grids here:
https://www.printables.com/model/1158507-drzak-mrizek-grid-holder-karak-carcassonne

Printer setting in my case - MK3S+, 0.2mm QUALITY, PLA silver.
____________________________________________________________________________________

This tile grid is also suitable for these inserts

https://www.printables.com/model/1251565-karak-1-vydani-1st-edition-insert

https://www.printables.com/model/1251582-karak-1-vydani-1st-edition-insert-s-vezi-with-tile

https://www.printables.com/model/1252582-karak-2-vydani-2nd-edition-insert

https://www.printables.com/model/1252591-karak-2-vydani-2nd-edition-insert-s-vezi-with-tile