Insert/Organizer for Forgotten Waters

An organizer for the game Forgotten Waters . Sized for cards with or without sleeves.

Print with 0.4 or 0.6 mm nozzle, 0.3 mm layer height, 15% gyroid infill, no supports. I strongly recommend using a brim for the spacers, to avoid warping. Print x numbers of card dividers as you see fit.

The large spacer that also doubles to hold the boards is too big to fit onto a Mk3S, so I broke it into two parts. Place the spacers first, then put the component boxes on top. The photos show where everything goes.

If you like what I'm doing…

… consider or joining my Club .