Lobotomy 2 - Manhunt

Insert for Lobotomy 2 Manhunt:

The insert is intended to help with faster set-up and tear-down, but also to support play (e.g. through the token and card boxes that can be used during the game). The card boxes are equally usable as a draw pile and a discard pile.

The insert holds:

Base Game

Hell Level Expansion

Jazza Ward - Character Expansion

Criminally Insane - Character Expansion

Villain Ward - Character Expansion

Legacy Ward - Character Expansion

3 Promo Characters from the SPIEL in Essen 2022

If desired: Extra Dice Pack

The lid closes exactly flush.

If you have an extra Dice Pack, you will find a variant in the insert:

In the STL files there are 5 STL files where the name starts with "Variant". You have to print these 5 STL files. In addition, there are 3 STL files in the STL file list where "Variant_exchange" appears in the name. You do NOT print these files. If you do not have an Extra Dice Pack, then you print everything except the 5 STL files whose name begins with "Variant". Each STL file is needed exactly once.

Normal Monster Trays:

The 4 normal Monster Trays are designed to be placed either upright or flat on the table. In both variants it is possible to put the monster card into the tray. If you want to lay the tray flat, you have to insert the card holders (Cardinsert_Minitray_1 through 8) into the slots provided by yourself. It's a bit tight, so it should hold well. But I also glued them additionally with plastic glue - see also last picture).

Miniatures trays in general:

The trays are designed so that the miniatures can't fall out if you tilt the trays. Therefore, there is a small bulge in the front where you insert the miniatures. Matching the miniatures, the corresponding cards are stored in the back of the tray.

The longest object is 221.5 mm long. Please note this if your printer has a corresponding print bed.

I printed the entire insert with a 0.4mm nozzle, with 0.2mm layer height and 10% infill.

The total material consumption was about 1,4 kg and took about 45 hours to print (but this depends on your printer).

The insert is suitable for sleeved cards.

The card boxes and the 4 monster trays are numbered on the back and bottom respectively, so that when you put them away, you know which stacks belong together when you sort them.

Happy printing!