Paleo Card Organiser (Sleeved cards)

Card Organiser for Paleo.

Thank-you to Andun_HH For his original model: https://www.printables.com/model/504625-paleo-expansion-card-organizer

Remix Changes:

• Has been remixed for sleeved cards.

• I used “Gamegenic Board-Game Sleeves - Green” these measure 59 x 91mm

• Only includes the base set of cards (no expansions)

• Includes sets 1 - 5 and A - J

• Card organiser base measures 160 x 105mm

• Internal dividing walls have been made slightly thicker for improved strength.

• Note that this WILL NOT fit in the original board-game-insert (It will fit inside the outer box). I had to fold/flatten my insert down a bit for it to fit. (Can be seen in photos)

• Token organiser pictured above: https://www.printables.com/model/777993-paleo-base-game-token-holder-remix

Andun_HH's Design Allows For Easy Access!

• Typical card organizers store the cards very tight and you can't grab the cards in the middle. To avoid this, the slots are alternating up and right.

• This allows you to either grab the cards on the right side or lift them up, by pushing down the edge. Just watch the gif and you get the idea. ;)

• The slots for the card sets are indicated with the corresponding number on the outside.

Print information:

• I printed in PETG, 3WL, 0.20mm layers. 15% Gyroid with arachne wall generation.

• Can be printed out of PLA same settings no problem. return to classic wall generation if that's your preference.