Evenfall

This inlay hosts Evenfall. It is designed for sleeved cards, but there is no reason to not use it with not sleeved cards.
You need to print the 03_EF_player box.stl 4 times.
The 10_EF_startmarker holder and the 11_EF_startmerker protector is a nice looking gimmick. I hope you like it.
Be careful when assembling the boxes: At the lid part of the hinge, you find a small notch, which makes it easier to snap in the lid. Take your time not to break the hinge on the box, check if the two pins are clear and have no plastic residue. If you accidentally break a pin, don’t panic, you don’t have to print the box again. Use a small paper clip, straighten the wire, heat it up (for example with a lighter) and pull it through the hinge. Clip off the rest of the wire and if you want, close the small hole with a little bit of the filament you used for printing – it is a perfect repair if needed.