The White Castle

This inlay hosts The White Castle with an insignificant box lift – max. 1 mm. It is designed for sleeved cards, but there is no reason to not use it with not sleeved cards.

You need to print the 01_WC_clan box 4 times. It is made to be put on the players board directly and you can still see the icons on the player board. I printed them all white because I believe this looks better on the player board, but you can also print them in the player’s colors.

The same goes for the 02_WC_player tiles print.

For printing the box for the dice, I give you two options. 04a can hold all dice but does not support the player boards as much as 04 which cannot hold all dice but has a better support. The lef over dice fit into the 11_WC_dice middle box.

Look at the foot to figure out how to best fit the bridges into 06_WC_bridge and helper cards box.

Be careful when assembling the money box: 03_WC_money box: At the lid part of the hinge, you find a small notch, which makes it easier to snap in the lid. Take your time not to break the hinge on the box, check if the two pins are clear and have no plastic residue. If you accidentally break a pin, don’t panic, you don’t have to print the box again. Use a small paper clip, straighten the wire, heat it up (for example with a lighter) and pull it through the hinge. Clip off the rest of the wire and if you want, close the small hole with a little bit of the filament you used for printing – it is a perfect repair if needed.