Star Wars Unlimited - Trilogy Deck Box - Data Vault Edition

This is a slight tweak to my original Trilogy deck box, adjusted to hold three single-sleeved 60 card decks. It features the same 4 slots for holding Ultra Pro Mini Snap or Gamegenic Slide Card Case card holders or you can print your own custom panels to go in those slots. The side panels should hold something 95.6mm x 69.6mm x 5.6mm (give or take with tolerances for your printer) if you want to create a blank panel or something with a logo. There are magnet holes (5x3mm) on the lid and base deep enough for 2 magnets in each hole. They won't be strong enough to keep the cards and token tray when held upside down or with a shake test so keep that in mind. The lid and the tray have also been reduced in size to create a lower height profile.

This was primarily printed on a Creality K2 Plus using the Creality Hyper PLA. 3 walls, 15% infill, 5 top and bottom shell layers and .2 layer height.