Kingdom Death Monster Gear Divider

These are the captions for the dividers I used for my gear holder box . They are designed to just stack on top of them.

• they should fit onto the dividers from by gear box (obviously)

• I want to read the locations from top
• this is one of the reasons I did not use the original dividers

• I decided to create two parts (divider + caption) to have more flexibility
• and my thought was to reduce the printing duration, because the font has to be printed with 0.2er nozzle, but I'm not sure if that was successful

• the captions are divided onto print plates sorted by the location release

• print whatever you need. Pay attention, some of them could be seen as duplicates (e.g. Dragon Armory vs Dragon King Gear) and probably you do not them both. It depends on your personal opinion how you want to sort them

• I printed them with a 0.2er nozzle with most details. The printing with 0.4er nozzle was not very successful, because the font size is fine

• the “connectors” (or however it could be called) are a bit fragile. One broke after it fall from the table (Bambu PLA basic)