Great Western Trail: Argentina - Insert & Organizer

As the title says, folks!

I've created a replacement insert for GWT: Argentina that aims to accomplish a few key tasks:

* Quick set-up & tear-down
* Storage with sleeved cards (1)
* Support for storage of metal coins
* Tray use during gameplay (2)
* **Vertical Storage** (3)

Print one of every tray. Note that the player trays are relatively identical, but mirrored to be able to store the solo board in-between them.

The trays have been split up to fit on medium-sized printers. A minimum width of 214.00mm must be supported. **Update**: The cards tray was previously larger than this. I've uploaded a LEFT and RIGHT version so that it may be printed in two parts.

1. Designed for, and tested with 60 micron Sleeve Kings sleeves. Larger sleeves may fit when compressed.
2. Card tray, coin trays, and player trays may be used during gameplay to organize components while playing.
3. Very important one for me. That said, my copy came with two sets of rulebooks and appendix sheets. Only one set is supported in the insert without lid lift.

### **Update 1**:
I've added two new prints that replace the old Setup.stl and Station Master.stl. The two new prints (Hats.stl, Setup V2.stl) swap the positions of player hats and Station Master tiles. What this effectively does is that it devotes the top layer to setup and stuff that goes on the table, while the bottom layer is fully player setup.

Please enjoy and feel free to share any feedback!