Log in to join the conversation.
Pandemic Token Holder Remix
I loved Roboticide's organizer for this but wanted all the tokens to have their own dedicated spots like the pawns did, so I raised a section so that the Research Centers would be the same height as the pawns (so the lid would hold them in place) and did the same for the other pieces. The two slots in the middle on one side are slightly wider than the others to accommodate the Infection Rate and Outbreak Markers. I have some other ideas, but all thanks goes to Roboticide for the design!
EDIT: Added a variation of the box implementing MaikaiGuy's "DImple Hinge": I just really wanted a hinged box so I gave it a try in Sketchup. Mine snapped in just fine, cannot comment on it's strength and longevity yet. Once it was in, i had to open and close it a few times to make it shut flush (there is technically a .25mm gap in the desing to give clearance to the hinge).
Pandemic 2008
Layer by Layer
Cover Colors
Pandemic: State of Emergency 2015
/pic9499648.png)
Pandemic: Government Shutdown 2014
/pic1632485.jpg)
Pandemic: In the Lab 2013
/pic9499647.png)
Pandemic: Isolation 2013
Pandemic: On the Brink 2009
1
Show 1 more
/pic517352.jpg)
Pandemie: Uitbreiding "De Generalist" 2009
) Pandemic Token Holder Remix by irmcdermott Aug 1, 2019 I loved Roboticide's organizer for this but wanted all the tokens to have their own dedicated spots like the pawns did, so I raised a section so that the Research Centers would be the same height as the pawns (so the lid would hold them in place) and did the same for the other pieces. The two slots in the middle on one side are slightly wider than the others to accommodate the Infection Rate and Outbreak Markers. I have some other ideas, but all thanks goes to Roboticide for the design! EDIT: Added a variation of the box implementing MaikaiGuy's "DImple Hinge": I just really wanted a hinged box so I gave it a try in Sketchup. Mine snapped in just fine, cannot comment on it's strength and longevity yet. Once it was in, i had to open and close it a few times to make it shut flush (there is technically a .25mm gap in the desing to give clearance to the hinge).
