Karuba Player Box

I had a hard time printing the tile boxes from woshee , the overhang just left strings everywhere. I rebuilt it from the ground up and added a 45* angle to make it easier to print. I added a few minor changes but kept the spirit of the original. Thanks woshee for a great idea!

I had good results with two different filaments. At first sometimes it is really difficult to slide in, but after a couple slides back and forth it should be nice and smooth. If it is still too tight sand the outside edge lightly. If it is too loose make the model .1 or .2mm wider in the width only--make sure not to scale the entire model.

Check out my Karuba Treasure Tiles Holder , and my Crystals holder , which makes it possible to store 2 copies in one box!

If you love board games check out my other designs here on Printables!