Whitehall Mystery component organizer

Simple organizers for the components of Whitehall Mystery. I tried some other STLs and they didn't fit my pieces this game was just purchased in the US from a fresh run March 2026 and these were sized based on that run.

There are 2 parts, one for Jack and 3 for Investigators. I printed jack in black and the investigators in white. Jack is a little taller and only has 4 tokens the investigators are a little shorter and have 5 tokens. These sit in the factory box, as shown in the picture, with the screen, map, and rule book just sitting on top.

I like that you can just pull these out and hand them to people, not that this game had a lot of setup anyway but now you don't need bags and the components are a little more protected when not in use.

These were printed at .2 layer height, with 15% infill, and they're plenty sturdy. I doubt the infill matters much most walls are small enough to be solid anyway. Print flat on the print bed no supports necessary should be a very easy print.