7 Wonders: Architects Medals Expansion Insert No Lid Lift Minimal Plastic

An insert designed to hold all expansion components, and common components, on top of the 9 player boxes with no lid-lift. I left a bit more room than necessary between trays but it ABSOLUTELY withstands a vigorous shake test.

You will take out:
The thin Medal Box
The thick box that holds the central cards and tokens

You will leave in:
9 Player boxes

You will print one of each:
Card Trays
Army holder (the one with squares)
Circle holder (for the Peace and Science tokens)
Medal Holder (the one with the weird shapes)

Each Medal slot holds 3 medals.
Each of the other slot holds 4 cardboard pieces.
There are only 6 peace tokens and 19 Science tokens so 3 of your circle holders will only have 3 tokens.

"No place for the Cat?" There is. I didn't print something out for it because if I leave the stand on, it's too wide for a printed holder. Just nestle it with the stand between the box and player boxes (see picture)

"Can this fit Sleeved cards?" Unless your sleeves are very thin I doubt it. There's extra room in the card caddy but not much. If you'd like to redesign the square holder to leave room for more cards I encourage you to. Alternatively you could split some of the cards into the player trays.

"What's with the round cut-out?" Helps you pull out any tray while not wasting plastic.