Tokaido organizer (sleeved remix)

Remix of "Tokaido organizer" by DROP_DB from https://www.thingiverse.com/thing:2737547

Working through my Tokaido set, these holders looked great for the tabletop, however I have my cards sleeved, and a quick check showed that the FFG Red sleeves were too big for the original holder. So, off to Tinkercad.

I printed the coin caddy, but noticed that I would like to see the colours of the players, but the placement on the table makes that difficult. Tinkercad to the rescue again, and having already raided available STLs for all things Tokaido, Nayen's "Tokaido Coin Upgrade" at https://www.thingiverse.com/thing:2442723 made a nice embossed mon that the nearest Sharpie colours would finish.

Update [1 October 2022]: The coin caddy has been shortened by 4mm to make it fit in the remixed holder.

Printer:

Artillery Sidewinder X2 (0.4mm nozzle)

Rafts:

Yes

Supports:

No

Resolution:

0.28

Infill:

15%

Filament:

Sunlu PLA+

White

Notes:

Normally I would use 0.20mm for a piece like this, but I am experimenting at 0.28mm layer height for storage instead of the normal 0.20mm. As a result, I am using brims to hold the prints to the hot bed.

Category: Toy & Game Accessories