Smart10 game box with lid

Remix to add a lid to keep cards from falling out and causing a mess. Both are privided in print orientation.

Flaws still present:

• The lid might not aim reliably in its receiver. This might depend on your card size (they could guide) and can be helped by carving a larger opening or slope. Slope might be difficult to print due to orientation but widening the receiver downwards should be easy enough.
• Original game set buttons will not fit here. Either print new ones from TPU or edit the model further.
• Round central hole is difficult to print.

Enhancement ideas:

• Score counters.
• A hinged lid that snaps in place when closed would be neat
• Round central hole is difficult to print. Perhaps 10-sided polygon would be cool.

Printing:

• Printed this with Prusaslicer, Ender 3 S1, translucent PLA.
• No supports
• 0.20mm
• Infill gyroid 10% but not important
• I forgot to set this myself and the result was ok-ish, but should have:
• extra perimeters on overhangs
• dynamic overhang speed down to 10mm/s