Invisible cassette case holder

This may be the most special interest thing I ever made. I store some of my Marvel Champions collection in cassette decks with custom covers. Check it out here , it's pretty rad. For storage I wanted a cassette case shelve but those are pretty expensive nowadays. So I made this as a more or less invisible storage solution.

It fits 9 cassette cases and is made to fit SPAX 3.9x22mm H2 flathead screws but all screws of similar size should fit. For easier customization I added a version without the screw holes and also a holder for a single cassette case.

If you liked this and can spare the money .

Print with the screw holes laying flat. I printed the wall and bottom soild which is absolutetly not needed, two walls and a bit of infill should add more than enough strength.

Screw to wall. That's basically it. Check if your screws fit beforehand but most screws of similar size should be fine.

The outer dividers are half the width of the inner dividers so when mounting multiple side by side the distance between cases stays the same.