The Artemis Project Insert

My contribution for an Insert for The Artemis Project (Kickstarter Edition of the Base game).

As for other inserts I create I aim for the following (in priority order):
* Enhance setup and tear-down part
* No need for covers of boxes but designed for horizontal and vertical storage
* Opted to store sleeved cards (as unsleeved cards will fit as well)
* Try to be as lightweight and resourceful as possible.

I hope I have achieved my goal.

For the enhanced setup phase I created individual player trays for each player that contains all required pieces including the starting resources. In addition, I added a tray for populating the academy - so you don't have to search and pull them from the bag/ship.
If the different buildings and cards are shuffled at the end of each game, the trays can be put 'as-is' on the table. For the building trays (in case of a 2-player game) I suggest putting the non-2-player tiles away once drawn.

The total amount of filament should be below 400g of your preferred filament.

For some trays (as they don't require a lot of strength) I printed them with no top or bottom layer and 10% honeycomb infill:
* Directive, Event, and Exploration card trays
* the Markers & Alien Relic Die (which can all the time stay in the box)
The 6 resource trays were printed with 15% infill (no bottom or top layer) to avoid the pieces being more prone to falling through.
For the Buildings and Multiplier Tokens, I added a Range Modifier from 0 - 4mm for 10% Honeycomb and no top/bottom layer, afterward regular printing profile (e.g. Lightning Infill with 2 Top layers).

I'm open to suggestions & feedback

Have fun printing