Dice Tower with Fold-Up Trays

Do you like rolling dice but hate trying to find them when they roll under your table? Here's a solution!

This dice tower will accommodate most standard dice sizes, but can be scaled up or down accordingly depending on your preference!

Remixed from garyacrowellsr's 'Remixed Angular Dice Tower, with trays'

Available for purchase from our Etsy!: http://etsy.me/1Zu1VJZ

Instructions

Print the following pieces. You will want to print at fairly high resolution (at least .2mm) because of the steep angle, otherwise it could be droopy.

1x tower.stl
2x tray.stl
4x pin.stl

Snap the pins into the holes on the tray, facing inwards, and then snap the tray to the tower. Repeat on the opposite side, and you're ready to play!

EDIT: It looks like some people are having trouble with the pins. I print the pins in ABS and they work well, but it's quite possible the pins don't print well in PLA.

Remixed Angular Dice Tower, with trays by garyacrowellsr

This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License .

Dice Tower with Fold-Up Trays by CarryTheWhat is licensed under the Creative Commons - Attribution - Share Alike license.