Karak / Carcassonne 4x4 tiles grid / grid

Translated from Czech · Karak / Carcassonne 4x4 tiles grid / mřížka

for Karak (2017) Layer by Layer

Ctihy

Board Frames & Overlays Free

View on Printables 73 695 2,234 Added Apr 4, 25 Support Ctihy by Liking and Boosting their model.

Designer's Description

With the original grid, the locks were too loose for my taste, so I adjusted the accuracy of the locks, the tightness of the tile boxes and slightly reduced the height of the separating crosses. Thank you very much for the original model, which I only slightly completed to my satisfaction.

There are two versions available - V1 is really very accurate in locks, V2 is a bit looser - try what suits you better.

Holder for up to 16 pcs of these grids here:
https://www.printables.com/model/1158507-drzak-mrizek-grid-holder-karak-carcassonne

I printed on MK3S+, 0.20 Quality, PLA silver.
____________________________________________________________________________________

Original tile grid have a locking bits with a little too much play on my MK3S+. I tried to modify the grid to have tighter locks and tighter tile arrays. There are two versions available – precise V1 and slightly looser V2.

Holder for up to 16 of these grids here:
https://www.printables.com/model/1158507-drzak-mrizek-grid-holder-karak-carcassonne

Printer setting in my case - MK3S+, 0.2mm QUALITY, PLA silver.
____________________________________________________________________________________

This tile grid is also suitable for these inserts

https://www.printables.com/model/1251565-karak-1-vydani-1st-edition-insert

https://www.printables.com/model/1251582-karak-1-vydani-1st-edition-insert-s-vezi-with-tile

https://www.printables.com/model/1252582-karak-2-vydani-2nd-edition-insert

https://www.printables.com/model/1252591-karak-2-vydani-2nd-edition-insert-s-vezi-with-tile

Translated from Czech - show original

U původní mřížky byly zámky na můj vkus až příliš volné, upravil jsem tedy přesnost zámků, těsnost políček pro dlaždice a trochu snížil výšku oddělujících křížků. Díky moc za původní model, který jsem jen lehce dotvořil ke své spokojenosti.

K dispozici jsou dvě verze - V1 je v zámcích opravdu hodně přesná, V2 je o něco volnější - vyzkoušejte, co Vám bude více vyhovovat.

Držák na až 16 ks těchto mřížek zde:
https://www.printables.com/model/1158507-drzak-mrizek-grid-holder-karak-carcassonne

Tisknul jsem na MK3S+, 0.20 Quality, PLA silver.
____________________________________________________________________________________