Table Talk
Nothing here yet. Love this design? Say so - the designer might see it.

Pitchcar Game Rails

Designer's Description

I made my own copy of the Pitchcar game and needed some rails. The track pieces have the same size slots as the original game pieces. Through a little trial and error I was able to come up with a rail profile that wedged itself nicely into the track pieces. The top of the rails are about 3.4mm wide and have a wedge profile toward the bottom that narrow to about 2.4mm. They straight rails are 21.5cm long and the curved rails about 26cm along the arc.

PitchCar box art PitchCar 1995 Layer by Layer
Cover Colors

Main colors from the cover art. Find matching filament, or tap swatches to narrow.

Matching filament

Submitted via BGG Geeklist
Jun 6, 2024 by Malachi
Updated Mar 19, 2025

- a hollow, hex grate track section without rails intended to be used for elevated track that crosses over other track to improve visibility. Note: this is designed to be printed upside down, so the print bed surface will be the track surface and bed adhesion is important. In my experience with other track sections, using a textured PEI bed will create more friction than using a smooth PEI, PEX, or glass bed. This may or may not be desirable, depending on your use case. The track was designed as a half track because a full track will not fit on an Ender 3 bed. PitchCar Game Rails