Log in to join the conversation.
Pitchcar Giant Loop
This is a giant loop for Pitchcar that has the same footprint as a left 90 then right 90. I split it into four pieces that fit on my Ender 3, just print then glue it together.
UPDATE 3/5/2019: I finally got the whole thing printed and it came out great. I ended up gluing together the track connectors to their respective loops, but not the loop halves together. This is to make it easier to store as well as to make it easier to fit into track layouts. I've included a picture of my finished loop in the thumbnails.
PitchCar 1995
Layer by Layer
Cover Colors
PitchCar: Extension 7 – The Loop 2019
/pic4438163.jpg)
PitchCar: Extension 8 – The Upsilon 2019
/pic4438165.jpg)
PitchCar: Extension 9 – The Adapter 2019
/pic6169839.jpg)
PitchCar: Foam Rail 2019
PitchCar: Extension 6 – No Limit 2016
/pic273632.jpg)
/pic4117593.jpg)
- another short straight looping section, this is much taller and it has rails that will guide the disc so it mainly just requires a power shot to make it up and around. It is also notable because it was designed in two sections that can both be printed without supports when properly oriented (well, I used supports for the grooves). This allows for much easier printing as well as storage. It has grooves in the top and bottom that allow a large rubber band to hold it together during play and some teeth that ensure alignment of the sections. PitchCar Giant Loop
