Table Talk
Nothing here yet. Love this design? Say so - the designer might see it.
Log in to join the conversation.
Guess Who Travel
Complete Game
Free
Designer's Description
This is a Travel Guess who. Use 1 inch photos.
When printing, if you want to use the emboss, set the first layer to .3mm and print emboss 1st. Then print the part, also with .3mm first later.
You will need 8 40mm M3 screws and 16 7mm m3 screws and 16 m3 nuts.
Included is a fit test. I recommend that you print the test fit and a single tile first to make sure everything is good.
There is a path to make it easier to install tiles. Have them perpendicular to the base and push down.
If you break a snap-fit off you can use CA glue to put it back down. If you break it off jagged file/sand it down and use the included snap fit stl to replace it.
