Targi + Expansion insert

Targi board game insert designed to hold both original game and the expansion. Box can fit sleeved cards (sleeves up to about 60 microns thick), I used Mayday standard sleeves. Card boxes have 1mm incline to prevent cards sliding out during the game.
All card boxes, silver and water token boxes have 0.5mm embossed labels to help sorting the components.

Resource and coins trays are ok with Geekup bits, tested by other users.

The insert fits in the Targi or The expansion game box without any gaps, so the pins on the component boxes are only meant to help position them on top of each other. Since all component boxes have different height and pin set, follow the placement instructions to pack the game box. You can rotate the boxes 180 degrees.
IMPORTANT: You might consider setting scale to 97% or 95% when printing. I printed my copy with 100% scale and gaps with the box are less than 2mm in total.

This is my first ever 3D design, so any comments and suggestions are welcome.

Photos show insert v0.1, resource and water token trays were slightly adjusted to better fit Geekup tokens.

Upd 26.05.2023
Added original model in SketchUp 2016 format.
Upd 22.09.2022
Tokens Setup v2 did not fit the start player token, thanks mrgigg for pointing that out. Replaced it with v3 option for Tokens Setup, still not tested.
Upd 12.03.2022
Replaces Tokens setup v3 with v4 (again, sorry about that). Now it will fit start player token (Kosmos English Edition) with a bit of slack space. Should be enough also if printed at 95-97%.