SEASIDE ESCAPE TikTok BOARD GAME

Famous tiktok board game.

The rules of the game are very simple, you can find the instructions by searching online videos.

ATTENTION: 32 pieces of the same subject are needed for each player, of which 4 for each figure (like the photos) for example Emoji vs Animal etc.

And you need a "START" piece. Good fun!!!

3d Printing settings:

FOR ALL PRINT:

Initial Layer Height: 0.2mm

Layer Height: 0.2mm

FOR THE PAWNS:

Layer Hight 0.2mm - infill 10%

Start with black and swap to white at layer #71

FOR START PAWN:

Layer Hight 0.2mm - infill 10%

Start with RED, Swat to BLACK at layer #6,

swap to RED at layer #11, swap to BLACK at layer #66

finally swap to RED at layer #71 until the end.

FOR THE CASES:

Layer Hight 0.2mm - infill 15%

Print verical position (see the plate pictures)

Use Brim

the x3 case is only compatible if you use 3 sliders,

and the x2 case is only compatible if you use 2 sliders

FOR THE SLIDERS:

Layer Hight 0.2mm - infill 15%

horizontal print (see the plate pictures)