Insert Muffin Time - 2024

This insert has been designed to make the most of the available space in the box of the board game **"Muffin Time"**. It consists of **3 main elements**, each with a specific function.

---
###Print Settings
- Layer Height : 0.2 - 0.3 mm
- Material : PLA
- Supports : No
- Infill : 5%

---
### **Box_card**
- **Description**: This box is dedicated to storing the **game cards**.
- **Dimensions**: **66 x 120 mm**.

### **Attention!**
The game cards have been protected with **protective sleeves**, which slightly increase their size:
- **Width**: Increases from **64 mm** to **66 mm**.
- **Total height of the card stack**: Reaches **120 mm**.

> **⚠️ IMPORTANT NOTE ⚠️**:
> The dimensions of the **Box_card** (66x120 mm) were specifically chosen to accommodate cards with protective sleeves.
>
> - If your cards **do not have protective sleeves**, you may not have issues with width, but the stack of cards might be too short and could fall inside the box.
>
> **📢 Request**: If anyone knows the exact dimensions of the card stack without protective sleeves, please leave a comment! I would be happy to design a new version of the **Box_card** with more suitable dimensions.

---

- **Description**: An **empty box** useful for storing:
- The **game rules**.
- Any **extra cards** or other components.

---

- **Description**: A small **fixed riser** that is placed at the bottom of the box. It serves to:
- Increase internal height.
- Keep the cards at the right height for easier access.

---

All the components of the insert are **separate from each other**, making it more practical and flexible to use.

---
### Support me
If you found this project helpful and would like to **support me**, you can do so via **PayPal** by clicking this link: paypal.me/Jvita307 . 🙏

Every contribution is greatly appreciated and helps me continue creating useful content and resources for the community! Thank you so much for your support! ❤️