In Too Deep - Insert - DO NOT PRINT

Edit 2023.04.16 - Uploaded a new version for the small cards tray (dilemma cards) as it didn't fit my sleeved cards (I use Sleeve Kings).

This was my very first insert design so it came with a slew of flaws that I would fix if I was not happy with the current result myself. I am sharing this in the event someone else wants to take this design and improve on it.

Borrowed the token tray holder from this design: https://www.thingiverse.com/thing:3613149

This insert does (somewhat) support sleeved cards, and was designed with the KS version. Box is flush so vertical storage should be fine (but haven't tested it myself at time of writing).

What you would need to print more than once:
#1 = 12x
#2 = 2x
#11 = 2x

What I would improve:
- Generally speaking a lot of the walls were too small (1mm) in the future I would always do 1.5 or 2mm.
- Combining subcomponents also wasn't always perfect so some printables have visibile lines where I combined them in the.
- The story card tray (#4) I botched dimensions-wise: level 1 and 2 have the same card count but for some reason I gave them different sizes of space.
- The tolerance tray (#10) was a smidge too wide for the tokens but then you probably also have to alter the spacers (#11).
- The VP tray (#6) could be altered to "transport" some of the space for the 50VP tokens to the 1VP tokens section.
- Finally the tray for solo cards doesn't perfectly fit for sleeves but it is also not wide enough (so there is some space in the box). I solved both "problems" by tucking the sleeved solo cards between the components.