Monster Slayers of Slawia insert / organiser

This model is a reinforcement for the original card dividers project created by siwymortis :

👉 siwymortis on Wspieram.to
👉 link to dividers

• First layer height: 0.28 mm
• Subsequent layers height: 0.20 mm

💡 Tip: The default height should provide sufficient rigidity. However, if you find the dividers too flexible, simply scale up the Z-height in your slicer.

• Print the divider bases.
• Print the divider graphics onto Self-Adhesive Photo Paper (a paper weight of 115 g/m² was used for the sample model).
• Stick the printed graphics onto the 3D-printed plastic dividers.

• Box Fit: Please note that the board game box will not close fully flush when using these dividers due to the extended height of the tabs.

• I have also included a small token box to help organize your game components!