Vantage Skill Tokens

These are multicolor printed with AMS at standard 0.2 profile. Slice with Arachne, slight error in yellow token otherwise.

Just a fun alternative implementation of the skill tokens but this time at poker chip sizes (39mm). They were redesigned and have both side symbols (mirrored). They have infill penetration because bambu doesnt allow to set specific infill filament causing bleed through. If anyone knows a different trick please leave a comment. The blue chip is the only one not tested but is currently printing.

The original is a good starting place, but has some issues: 1 - Double sided. The original is only single sided, and these have been switched to provide the pattern on each side (you won't see this in the Prepare tab, but you will see it in the Preview and when printed). 2 - Too Big. The correct size for each token should be 18x18x5mm. (The original is 20x20x10) 3- Top and Bottom Patterns. Switched to Concentric to give it a nicer look. 4 - Infill. Cranked up the infill percentage to give the tokens heft. They feel much more like full tokens this way instead of cheaper plastic. 5 - Smoothness. I am using the smooth plate, so I also turned on ironing to make sure both sides are as smooth as possible.